Although the key to the cutting of flat and medium-thick plates is opened and executed by special tools, employees are still needed at the side of the equipment. In fact, steel plate cutting is better understood, which is to use cutting technology, and the purpose is to effectively use resources without damaging the environment. . And can facilitate transportation.
As a common raw material, steel plate has many cutting techniques, but no matter what kind of technique, you should pay attention to when opening the material. Be sure to check the information content before opening the material to avoid remaining errors. . Before cutting, it is necessary to check whether the equipment and special tools can be used normally and can operate under safe conditions. During the whole process, the spacing of the cutting torch should be adjusted, and the compensation of the slit should be fully considered. The elements are fully assured.
The front-touch steel plate cutting includes a laser transverse rack, which is set up on a prepared slide rail. The medium-thick plate cutting template is made of steel plate or cutting template, and the steel plate cutting template has support points in the grid node. , The unit frame is arranged on both sides of the frame, and the gears that are engaged with the unit frame are arranged in the transverse frame of the laser, and there are multiple steel bars in the middle of the frame, thus meeting the different needs of steel plate cutting and cloth.
Because of the development of society, in the sales market, the rules for steel plates are getting higher and higher, the demand is also increasing, and steel plates can often be seen, which shows that its use is still relatively popular. After proceeding, in order to better facilitate the transportation, it is necessary to cut and process the steel plate appropriately. The goal is not only to control the cost and increase the company's profitability, but also to consider the requirements of small and medium-sized enterprises.
At the same time, the rack and pinion of the transverse frame is moved from the laser, which has better transmission accuracy. A few steel bars are placed in the frame to make the frame more stable during the cutting process and meet the needs of faster cutting operations. It is an important process of steel structure processing. The quality of the seal directly affects the subsequent welding and assembly, which in turn affects the quality of steel products. At the same time, the efficiency of steel plate cutting directly affects the progress of steel component processing and consumption, which is an important element in calculating the cost.